Manual

55
- Modem will go to DFU mode. Press UPGRADE button in
the DfuSe program
- After a couple of seconds, the DFU will be uploaded to the
modem. Make sure it takes 1-3 seconds and does not
happen immediately. Otherwise, the SW has not been
uploaded correctly. If the DFU appears to upload
immediately, check the "Choose" button you used or
change the version of DfuSe SW to a different one
- Disconnect the short circuit
- Start the Dashboard and press RESET button
- If you experience difficulties in DFU programming, please try
the following:
- Use a different computer with a different version of
Windows or another operating system
- Install a different DfuSe version (whichever works best
with your Windows)
If you have uploaded the latest firmware for all the boards, you can start to
activate the system:
4.2.6 While the beacon or modem is connected to the Dashboard, click
the DEFAULT button on the Dashboard to upload the default
settings