Operating Manual

11
4.1.18 It may take up to 7-10 seconds for the beacons to wake up
4.1.19 Notice, that if the modem is not active and is not powered, the
beacons will go into sleep mode automatically after 1 minute
4.1.20 The system may run the frequency search, if it is the very first time
you are waking up the beacons. If this step does not work,
disconnect the modem and connect that beacon again via USB.
Press the DEFAULT button in the Dashboard and the Read All
button to make sure that the radio settings are the default ones
4.1.21 Check that the radio settings on the modem and the radio settings
on the beacon are the same
4.1.22 Now you can check RSSI, voltage, ultrasonic filter settings, etc. on
the panel on the right corner of the Dashboard
4.1.5 Enter the height of stationary beacons. Choose beacon in the list
and enter height value
4.1.6 Enter the height for mobile beacon if you use 2D mode
4.1.7 In the current version one modem supports 250 beacons (mobile +
stationary combined). If you do not see some of your connected
beacons on the map, you may need to scroll to find their addresses
4.1.8 Double click on the device both to put it into sleep mode and to wake
it up
4.1.9 The map will form and zoom in automatically