Operating Manual

5
2. Super-Beacon
The Super-Beacon is a dual-use beacon – it can both
receive and transmit ultrasonic pulses.
The Super-Beacon Beacon can be used in both the Non-
Inverse Architecture (NIA) and the Inverse Architecture (IA):
Architecture comparison.
Supports license-free 915MHz ISM band (US/Japan).
Key features:
- The Super-Beacon has a separate receiving part
with a single wide-beam microphone and sharp
DSP filters (like Mini-RX or Industrial-RX has).
Thus, it is more sensitive, than Beacon HW v4.9,
more resistant to external noise, and easier to setup, because you do not have to
care about turning on and off ultrasonic sensors to optimize coverage vs.
sensitivity
- The Super-Beacon can receive any ultrasonic frequency from the bands: 19kHz,
25kHz, 31kHz, 37kHz, 45kHz. The filter can be simply selected in the Dashboard.
At the same time, the ultrasonic frequency of Beacon HW v4.9 is HW-defined by
ultrasonic sensors and can’t be changed
- The Super-Beacon has several-times improved battery lifetime in TX mode as
compared with Beacon HW v4.9
- The Super-Beacon can work with regular Beacons HW v4.9 and Mini-RX and
Industrial-RX in any combination as a part of a Starter Set or as a part of
navigation systems. In all cases, beacons shall use the same radio band
Demo video: https://www.youtube.com/watch?v=cIA2Gc5KaQI