Operating Manual

6
3. Setting up the system (NIA)
3.1 Starter Set Super-NIA-3D
The steps below describe the very first time you set up of the system. Super-beacons
and modem required.
4.1.5 Unpack the system. Look at a similar unpacking video of HW v4.9. The
videos have certain differences but the basic are the same:
https://youtu.be/sOce7B2_6Sk
4.1.6 Charge all the beacons using USB cable. Full charging takes about 1-2
hours
4.1.7 Turn the beacons on: Place DIP switches as shown on the picture below
4.1.8 Download SW Pack
4.1.9 Update all the beacons (HEX programming):
‒ Run the Dashboard and update the SW for all beacons and
modem using Dashboard => Firmware => Choose the file =>
Program