Operating Manual

8
- Choose the DFU driver (file) for the beacon
- Click the UPGRADE button
- After a couple of seconds, the DFU will be uploaded to the
beacon. Make sure it takes 1–3 seconds and does not
happen instantly. Otherwise, the SW has not been
uploaded correctly. If the DFU appears to upload
immediately, check the "Choose" button you used or
change the version of DfuSe SW you selected
- Move the DIP switch into Power = ON, DFU = OFF
- Start the Dashboard and press the RESET button on the
beacon
- Check SW on the beacon afterwards
- Everything should be OK with SW now. DFU programming
is complete
- Follow the same scenario for the modem:
- Here is the link for the modem DFU programming. The
steps are similar to those for beacon DFU programming
- After uploading DFU driver by DfuSe short circuit pins as
shown on the picture (for v5.1) and press Reset button