Operating instructions

When the display stops flashing, it will re-display EC, E1 or E2 depending upon which

combination you were entering. Now reinsert the Change Key and dial in the new

combination of your choice.

NOTE:

If you misdial or do not properly finish the Change Key sequence in

any way, the X-07 automatically reverts to the previous combination(s). The

old combination remains valid until a new combination is confirmed.

Let the lock completely power down and then try the combination again.

CAUTION:

After you have confirmed your new combinations, make a record

of the new numbers and test dial the combinations before closing the door

or container.

LOCKOUT PREVENTIONLOCKOUT PREVENTION

LOCKOUT PREVENTION

If the door of your container is shut and the X-07 accidentally locked with the Change

Key still inserted in the Change Key slot, allow the lock to power down. (After 40 seconds

the display will go blank. Wait an additional minute for full power down.) You can then

open the lock by turning the dial to the Right until power up occurs (numbers appear).

Then dial the current combination in the correct sequence.