Operating instructions

ManualsBrandsMas-Hamilton ManualsAutomotiveXX-07

RESETTING COVERT ENTRY AND COVERTRESETTING COVERT ENTRY AND COVERT

RESETTING COVERT ENTRY AND COVERT

ENTRY COMBINAENTRY COMBINA

ENTRY COMBINA

TION CHANGETION CHANGE

TION CHANGE

This procedure works only if the lock is powered down with the Change Key out of the

lock.

Dialing to the right (CW) on lock startup will display the open counter. If the open

counter is not displayed, the lock has not yet powered down. If there is a covert entry

or the Change Key is in, continuing to dial to the right will result in dialing an ID. The

ID is selected when direction is reversed. The lock level is not displayed when the

Change Key has been inserted or there has been a covert entry. Instead, the num-

bers for selecting an ID are displayed.

Dial to 99 and reverse directions. After reversing directions, dial the covert entry combo

starting to the left as with the other combinations. If the combination is correct, the

covert entry condition will be reset.

The default covert entry combination is 50 25 50.

To change the covert entry combination, dial to the right until the open counter is

displayed. The Change Key needs to be inserted during the open counter display. If it

is in before the open counter display, it will not be recognized. Begin by dialing right to

ID 99 and then dialing the current covert entry combination. If the combination is

correct, you will be able to enter and confirm the new covert entry combo the same as

changing a single normal combination. The lock will open upon completing the com-

bination change.

RECORECO

RECO

VERING IF THE COVERING IF THE CO

VERING IF THE CO

VERT ENTRY COMBINAVERT ENTRY COMBINA

VERT ENTRY COMBINA

TIONTION

TION

IS FORGOTTENIS FORGOTTEN

IS FORGOTTEN

With a covert entry condition on the lock, the lock can be opened by dialing the cor-

rect combination 5 times in a row successfully. The lock must stay powered up be-

tween the combinations. A lightning bolt will be displayed between each combination.

The CE condition is not reset.

If in dual combination mode, both combinations must be dialed 5 times in a row suc-

cessfully.

If in supervisor/subordinate mode, the lock can still be set between locked up and

unlocked status with the supervisor combination. The lock needs to be in unlocked

status and the subordinate combination dialed 5 times in a row successfully.

Once the lock is opened, the serial number can be obtained from inside the back

cover of the lock.

With a CE condition on the lock and the Change Key inserted, the CE reset combina-

tion can be changed as follows:

1. Dial the combination to the lock. Enter Serial number (ES) will be shown.

2. Dial the serial number. Enter Combination (EC) will be shown.