Operating instructions

OPENING THE X-07OPENING THE X-07

OPENING THE X-07

USING THE PREUSING THE PRE

USING THE PRE

SET COMBINASET COMBINA

SET COMBINA

TIONTION

TION

Your X-07 lock has been shipped pre-set in the Single Combination Mode with the

combination set to 50-25-50.

Practice opening the lock several times before you set a new combination.

Your X-07 uses sophisticated computer security and makes dialing much easier than

that of traditional combination locks.

The X-07’s computer recognizes a number as being part of a combination when you

stop dialing on that number and then reverse dialing directions. This enters the num-

ber into the computer memory.

If at any time the dial remains stationary for more than 40 seconds, the computer will

reset (LCD will go blank) requiring the operator to redial the entire combination.

Important: The X-07 has protective software that detects robotic dialing. If robotic

dialing is detected, the X-07 will not open even if the correct combination has been

dialed.

The user should dial with complete full wrist turns. Stopping to regrip produces pauses

in dialing activity. This helps the X-07 distinguish between human and robotic dialers.

The X-07 may mistake a human for a robot if the user:

1. Dials more than 1.3 revolutions in either direction with no pauses in dialing

activity;

2. Dials with very short, quick repetitive turns, producing very short pauses in

dialing activity;

3. Dials a combination in less than 15 seconds.

TO OPEN THE X-07:TO OPEN THE X-07:

TO OPEN THE X-07:

1. Dial left (counterclockwise) 4-6 turns to “power up” the lock. Numbers will appear

on the LCD display screen.

OPENING THE XOPENING THE X

OPENING THE X

-07-07

-07