User Manual

RFAF
PWR
MIC
AF OUT
LINE
CHANNEL SQ
DC INPUT
12V 500mA
WI RELESS
PRODUCT DESCRIPTION
3
10
SETTING UP
WIRELESS
5.1.2 Single Channel, Mini Case
Non Diversity, Front Fixed Antenna
1
7.3 Setting up channel on receiver
Notice: Do not put two or more transmitters operating nearby when setting up the frequency
channel. Please keep transmitter at least one meter away from receiver.
 Use the AC adaptor to connect the DC input connector for on the receiver and check the
frequency.
 The power LED lights when the receiver is ready to operate
 Adjust dip switch to set the channel
 If user need to set up a multi-receiver system, please keep your previous
receiver-microphone pair power on. Then go on to next set up procedure.
 Make sure the receiver channel is same as the transmitter channel
7.4 Inserting batteries into the handheld / bodypack transmitter
 Push to open the battery cover and insert batteries into the battery compartment
conforming to the polarity (+)(-) marks. The transmitter can not work with incorrectly
inserted batteries.
 When push the ON/OFF switch to “ON” to switch the power on, the LED will flash
momentarily.
If the battery has sufficient power, the LED flashes once. If the LED stays on, it indicates
that the battery has insufficient power and should be changed soon. If the status LED
fails to flash, the battery is either dead or not positioned correctly, and you should correct
the positioning or change the battery.
 Push back the battery cover to click it shut.
7.5 Setting up the handheld transmitter
 Use the AC adaptor to connect the DC input connector for on the receiver and check the
frequency.
 Switch the transmitter and hi-fi appliance (amplifier, tape deck etc.) power on.
 Adjust the channel setting of the transmitter according to receiver’s channel setting
 Test the microphone and adjust the levels on your audio mixer or amplifier.
2
3
5
7 8 9
10 12