User Manual

WI RELESS
BASIC CONNECTIONS
6
PRODUCT DESCRIPTION
WIRELESS
7
5.3 Bodypack Transmitter
The bodypack transmitter operates in UHF band frequency with PLL synthesized control.
UHF 16 preprogrammed selectable frequencies to avoid interference. Uni-directional
condenser cartridges with different characters for various choices. Use 1.5V x 2 AA size
dry or rechargeable batteries for low operating cost.
1. Mini XLR /3.5
ϕ connector: The included electret lapel microphone is
inserted into the connector on transmitter.
2. On/Off Switch: Turns transmitter power on and off.
3. Low Battery LED: LED indicates battery life status. Switching the power to
"ON", the LED flashing once indicates that the transmitter has sufficient power.
If the LED stayed on, it indicates that the battery has insufficient power and
should be changed soon. If the status LED fails to flash, the battery is either
dead or not positioned correctly, and you should correct the positioning or
change the battery.
4. Mic/Line Selector (optional for use with mini XLR connector) : The
switch sets the audio input either to microphone level or line level.
5. Antenna: Permanently connected, helical antenna.
6. Channel Selector: Changes transmitter Channel setting.
7. Gain: The rotary control adjusts the sensitivity of the transmitter’s audio to
the level of the connected lapel microphone or instrument.
8. Mic Unit: The uni-directional electret condenser unit features the wide
frequency response for warm, rich bass and clear sound.
9. Tie Clip: To clip on the tie or lapel for free-movement.
10. Cable: With mini XLR jack or 3.5ϕ screw type plug cable to connect the
transmitter.
11. Battery Compartment: Insert two AA batteries into the compartment and
make sure that the polarity of batteries is correct.
1 2 3 4
5
6
7
8
9
11
5.2 Handheld Microphone
The handheld microphone operates in UHF band frequency with PLL synthesized control.
UHF 16 preprogrammed selectable frequencies to avoid interference. Uni-directional
dynamic or uni-directional condenser capsules with different characters for various choices.
Use 2 x DC1.5V AA size dry or rechargeable batteries for low operating cost.
1
2
3
4
5
7
6
1.Grille: Protects the microphone capsule and helps reduce breath sounds and wind noise.
The grille for the various microphone capsules differ in appearance.
1. Low Battery LED: LED indicates battery life status. Switching the power to "ON", the
LED flashing once indicates that the transmitter has sufficient power. If the LED stays on, it
indicates that the battery has insufficient power and should be changed soon. If the status
LED fails to flash, the battery is either dead or not positioned correctly, and you should correc
t
the positioning or change the battery.
2. On/off Switch: Turns transmitter power on and off.
3. Battery Compartment: Insert two AA dry or rechargeable batteries into the compartment
and make sure that the polarity of batteries is correct.
4. Channel Selector: Changes transmitter Channel setting..
5. Battery Cover: Unscrew to expose battery compartment and Channel selector.
6. Antenna: Built-in high gain helical antenna
10