z Introduction............................................................................. 1 - FCC Statement - Safety - Environment z Product Description.................................................................. 2 - Receiver - Handheld Microphone - Bodypack transmitter z System Operation..................................................................... 6 - Connecting the Receiver - Set up the Handheld Microphone / Bodypack transmitter z Trouble Shooting..................................
INTRODUCTION WIRELESS z Introduction Thank you for purchasing our product. This PLL synthesized wireless microphone system operates in UHF band frequency with 16 selectable channels. Please read this instruction manual carefully before operating the system. This manual covers the function and operation of the wireless microphone system. FCC Statement This device complies with part 15 of the FCC rules.
WIRELESS PRODUCT DESCRIPTION z Product Description ¾ Receivers The receivers are used with our 16-channel selectable channels transmitters. (The number of frequency channels depends on local regulations.) The receiver operates in UHF band frequency with PLL synthesized control. Powered by 12V DC. ! ¾ Single Channel Switching Diversity, Front Fixed Antenna 1 2 3 4 4 1.Antenna 2.Power Indicator: The LED lights up to show the receiver is ready to operate. 3.
PRODUCT DESCRIPTION 1 2 3 WIRELESS 4 5 6 1. Balanced XLR Audio Output 2. Unbalance 6.35mm Audio Output 3. MIC/LINE Switch: Use this to adjust the audio output level for MIC level (-20dB) or LINE level (0dB). 4. Squelch: Turn the switch to adjust or decrease the noise floor level. 5.
WIRELESS PRODUCT DESCRIPTION ¾ Handheld Microphone 1 2 5 4 6 7 3 1. Grille: Protects the microphone capsule and helps reduce breath sounds and wind noise. The grille for the various microphone capsules differ in appearance. 2. Power LED: Indicate the power / low battery level status. LED Indicator Status Red Ready Flashing Red Low Battery power when less than 10 minutes operation 3. Power: Press for 2 seconds to turn transmitter on or off. 4.
WIRELESS ¾ Bodypack Transmitter 1. Power / MUTE Button: Press for 2 seconds to power the microphone on or off. With the transmitter on, a slight press for button will toggle between mute and unmute function. 2. 3.5Ø Connector: connect to the lapel microphone or headset microphone. 3. Power / MUTE LED: Indicate the power / mute / low battery level status.
SYSTEM OPERATION z Connecting the receiver Prior to setting up, please check that the transmitter and receiver are tuned to the same frequency or channel. Two or more transmitters operating in the same frequency can not be used at the same time and area. AC/DC ADAPTER 1 2 ¾ Connected the provided DC power supply to the receiver power input with an appropriate AC power source. The power LED display will light and the receiver is on. ¾ Using a standard audio cable with 3-pin XLR connectors or 6.
SYSTEM OPERATION z Set up the handheld microphone / bodypack transmitter OP EN ¾ Open the battery cover and insert batteries into the battery compartment conforming to the polarity (+)(-) marks. ¾ Unscrew the handheld Mic and open the battery cover to insert the battery into the battery compartment and confirm the marks of the polarity (+) (-). 11 12 1 10 2 9 11 3 8 4 7 6 5 12 1 10 2 9 ¾ Press for 4 seconds to turn the Handheld/ Bodypack transmitter on.
TROUBLE SHOOTING WIRELESS z Troubleshooting Problem Solution No sound ¾ Check the power supply of the microphone and receiver. ¾ Check that the transmitter and receiver are tuned to the same frequency. ¾ Check whether the hi-fi appliance is switched on and the receiver output is connected to audio mixer or amplifier input. ¾ Check whether transmitter is too far away from receiver or SQUELCH control set too high.
FEATURES & SPECIFICATION WIRELESS z System Specification Receiver ¾ ;; ; @; Z" [\ ] ^ ¾ Case ¾ _`[ {{ ; ¾ "{ ¾ @; Z" [\ > | { \ ¾ >= ; ¾ $ ^ > "; "` ] } [ ¾ ] [ ^ > ` \ ¾ Selectivity ¾ '@ ] ` ` ¾ T.H.D. ¾ @ @; Z" [\ ¾ ?\ $ [ ] ^ ¾ ~ > ^ { ¾ '" _" " ¾ ; >" {\ ¾ ";; `"$ ¾ Dimension (mm)W×H×D : UHF 520 - 698MHz : Mini case : PLL Synthesized : FM ±20KHz : ±0.
FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example use only shielded interface cables when connecting to computer or peripheral devices).