User's Manual
6
Connected the provided DC power supply to the
receiver power input with an appropriate AC
power source. The LCD display will light and the
receiver is on.
¾
Using a standard audio cable with 3-pin XLR
connectors or 6.3mm phone plugs to connect
the mixer or amplifier.
¾
Set the audio output level for
MIC: -20dB
LINE: 0dB
¾
Using the Volume Controller to adjust the AF
audio level to the input of the amplifier or mixer.
¾
Never use the balanced and unbalanced audio
outputs at the same time! This may cause
signal loss or increased noise.
zConnecting the receiver
Prior to setting up, please check that the transmitter and receiver are tuned to the same
frequency or channel. Two or more transmitters operating in the same frequency can
not be used at the same time and area.
1
2
3
4
AC/DC
ADAPTER
LINE MIC
Use squelch to avoid reproducing noise when
the receiver does not receive enough signal from
the transmitter.
¾
Turn clockwise to increase squelch and reduce
noise. When turning the squelch knob clockwise,
it begins to eliminate background noise.
-
When the squelch is all the way to the left, the
squelch is off and the ambient RF noise will be
easily to receive.
-
5
SYSTEM OPERATION