User's Manual

WIRELESS

WIRELESS NOTE

FCC Statement

This device complies with part 15 of the FCC rules. Operations is subject to the following two

conditions: (1)This device may not cause harmful interference and (2) This device must accept

any interference received, including interference that may cause undesired operation

Notice : The changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no

change to the antenna or the device is permitted. Any change to the antenna or the device

could result in the device exceeding the RF exposure requirements and void user’s authority

to operate the device.

1. Introduction

Thank you for purchasing our product. This wireless microphone system operates in UHF

band frequency with synthesizer controlled. The system with 16 or 64 selectable frequencies

via Phase Locked Loop (PLL) circuitry makes it easy to choose non-interfered channels.

Please read this instruction manual carefully before operating the system. This manual

covers the configuration and operation of the wireless microphone system.

2. Safety

Ø Do not spill liquid on the appliance and do not drop it on a hard concrete floor.

Ø Do not place the appliance near heat sources such as radiators, amplifier, or etc. Do not

expose it to direct sunlight, extremely dust, excessive moisture, or vibration.

Ø Take out the battery from transmitter, if the appliance has been not used for a longer

period. This will avoid the damage resulting from a defective leaking battery

3. Environment

Ø Do not throw used batteries into a fire or garbage bin with domestic rubbish. Be sure to

dispose of used batteries in accordance with local waste disposal rules.

Ø When disposing the equipment, remove the batteries, separate the case, circuit boards,

and cables, and dispose of all components in accordance with local waste disposal rules.

4. Wireless Note

Ø Before setting up, make sure that the transmitter and receiver are tuned to the same

frequency.

Ø Do not use two transmitters in the same frequency.

Ø Use good quality batteries to avoid the damage resulting from a defective leaking battery.

Ø To avoid interference, do not put the receiver too near metal object and avoid obstructions

between transmitter and receiver.

Ø Avoid the interference from TV, radio, other wireless appliances and etc.

Wireless Microphone