User's Manual

L
I
N
E
M
I
C
N
B
A
L
A
N
C
E
D
Prior to setting up, please check that the transmitter and receiver are tuned to the same
frequency or channel. Two or more transmitters operating in the same frequency can not
be used at the same time and area.
VOLUME
M
I
C
S
Q
D
C
1
2
V
5
0
m
i
n
.
S
Q
m
a
x
.
S
Q
Connected the provided DC power supply to
the receiver power input with an appropriate
AC power source. The LCD display will light
and the receiver is on.
Set the audio output level for
MIC: -20dB
LINE: 0dB (Default Setting)
Using the Volume Controller to adjust the AF
audio level to the input of the amplifier or mixer.
Never use the balanced and unbalanced audio
outputs at the same time! This may cause
signal loss or increased noise.
Use squelch to eliminate or suppress the
ambient RF noise.
Using a standard audio cable with 3-pin XLR
connectors or 6.3mm phone plugs to connect
the mixer or amplifier.
Default Setting: In minimum VOLUME position.
Defaulting Setting: In properly position.
10
Connecting the receiver