Manualshelf

User's Manual

ManualsBrandsMasimo ManualsElectronicsRad-87
61626364656667686970
4-32
Rad-87 Pulse CO-Oximeter Operator’s Manual
4
Operation
Setup Menu Level 3, continued
Device Profile Setup and Use
The Rad-87 can be configured to save changes to the instrument settings as a Device Profile.
Using the Rad-87 button menu or an external configuration application, users can adjust Rad-87
settings and parameter/measurement alarm limits. After changing settings, the user may save the
settings as a Device Profile. This Device Profile becomes the new default settings and the saved
(Device Profile) settings will be retained after a power cycle.
To save the settings as a profile from the Rad-87 button menu, the user must enter Setup Menu
Level 3 by pressing and holding the Enter Button and Down Button at the same time for 5
seconds. Then, by pressing the Enter Button three times, the Default Settings screen is displayed.
Press the Up or Down Arrow Button until “User Default – Set” is displayed on the LCD. The user
can press the Enter Button again to save the settings.
Using an external configuration application, the user can save up to five profiles. The user may
select a color for the Device Profile LED to associate with the saved profiles. The Device Profile
LED (located on the front panel of the Rad-87 above the sensor connector) will illuminate with the
selected color, allowing the user to verify at a glance that a Device Profile has been set on the
Rad-87. If changes are made to the instrument settings after the Device Profile feature has been
enabled, the Device Profile LED will turn off until the instrument is returned to the user configured
default settings or powered off, indicating a change from the Device Profile settings.
To set a instrument profile, the user enters Menu Level 3 by pressing and holding the Enter Button
and Down Arrow Button at the same time for 5 seconds. Then, by pressing the Enter Button three
times, the Default Setting screen is displayed. The user can use the Up or Down Arrow Button to
select the desired profile and press the Enter Button to save the setting.