5 Manual G2.
6 Manual G2.
9 Machine How to charge the machine Connect C cordcord into Connect the the USB USB charger charger plug plug or or aa compatible compatible type micro-USB machine and to a polarized outlet. Be sure to charge fully before into the machine and to a polarized outlet. Be sure to charge each use. The indicator light on the back of the back machine will turn fully before each use. The indicator light on of the on to indicate charging and power. machine will turn on to indicate charging and power. Manual G2.
10 Microphones How to charge the microphones Place the microphones in the charging docks on the machine or plug them into a compatible charger using the micro-USB charging cable. Be sure to charge fully before each use. While charging, the top bar of the battery icon on the display will flash, then stop flashing when the battery is full. How to turn the microphones on Remove the microphones from the charging docks and turn them on using the power button on the handle.
11 How to customize your microphone vocal mix To adjust the volume of your singing over the music, click the Volume +/- buttons up or down until it reaches your preferred volume. To modify the reverb effect on your singing, click the Echo +/buttons up or down as desired. Use the EQ button to choose between 5 different equalizer selections. Operation Frequency: 490.5MHz Manual G2.
14 Problem Solution Battery icon on the microphone screen is blinking The microphone battery is low or depleted. Microphone will not turn on Charge before use. Machine is not playing microphone vocals Ensure that each microphone is on a separate frequency band. This is represented by CHA or CHB in the bottom left corner of the microphone LED screen. (To switch channels, hold down the A-B button for one second).
FCC Statement This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
