Installation Guide

3/4" (19 mm)
1/4"
(6.3 mm)
1/8” (3.5 mm)
Position rollers minimum
of 4” (101 mm) from edge
Drill Depth
XXX”
(XX mm)
3/4" (19 mm)
1/4"
(6.3 mm)
1/8” (3.5 mm)
Position rollers minimum
of 4” (101 mm) from edge
Drill Depth
XXX”
(XX mm)
3/4" (19 mm)
1/4"
(6.3 mm)
1/8” (3.5 mm)
Position rollers minimum
of 4” (101 mm) from edge
Drill Depth
XXX”
(XX mm)
1
DOOR
PREPARATION
NOTE: a second optional wall-mounted door
guide has also been provided in this kit
should you not wish to mortise your door.
Mortise 1/4" wide x 3/4" deep groove centrally to the
bottom of the door for use with the floor-mounted
door guide. This will ensure smoothness of door travel
side-to-side and will prevent the door from swinging
in and out.
If you prefer, you can also have your door mortised at
the store you have purchased your door (typically, for
an additional charge). See your store for details.
2
DOOR PREPARATION
ROLLER INSTALLATION
Position each roller a minimum of 4"
from the edge of the door.
Mark the first hole with a pencil and pre-drill
1/8" holes, then secure into place. Mark the
second hole with the roller in place to ensure
the roller is secure. Repeat for second roller.
3
DOOR PREPARATION - ANTI-JUMP
BLOCK INSTALLATION
Position each anti-jump block at least 1" from the
edge of the rollers. Tighten slightly to secure in place.
Barn Door Installation Guide
BARN DOOR HARDWARE TOP MOUNT KIT
©2017 Masonite International Corporation. MIC-171901 1-800-663-DOOR masonite.com