Installation Guide

renincorp.com • acmesystemsandhardware.com
BARN DOOR HARDWARE KIT
BD101K-07800
ASSEMBLY INSTRUCTIONS
Step 1. Door Preparation
Note, a second optional wall-mounted door guide has
also been provided in this kit should you not wish to
mortise your door.
Mortise 1/4" wide x 3/4" deep groove centrally to the bottom
of the door for use with the oor-mounted door guide. This
will ensure smoothness of door travel side-to-side and will
prevent the door from swinging in and out.
If you prefer, you can also have your door mortised at
the store you have purchased your door (typically, for an
additional charge). See your store for details.
3/4" (19mm)
1/4"
(6.3mm)
Step 3. Door Preparation – Anti-jump block Installation
Position each anti-jump block at least 1" from the edge of the
Straps. Tighten slightly to secure in place.
Step 2. Door Preparation – Strap Installation
Position each Strap a minimum of 4” from the edge of the
door and 1.5” from the top of the door. Mark holes with a
pencil and pre-drill 3/8” holes, then secure into place.
Repeat for second strap.
4" (101mm)