Installation Guide

1
ATTACHING ROLLER
TO DOOR PANEL
Position each roller 4" from the edge of the
door and centered.
Mark the first hole with a pencil and pre-drill
1/8" holes, then secure into place. Mark the
second hole with the roller in place to ensure
the roller is secure and straight on the door.
2
DOOR PREPARATION - ANTI-JUMP
BLOCK INSTALLATION
Position each anti-jump block at least 1" from
the edge of the rollers.
The hole for the anti-jump blocks should be
offset from the center of the door so the block
can be rotated out of the way to be able to
hang the door on the track. (FIGURE 2)
NOTE: For concrete wall installation
proceed to step 3. For Drywall
installation proceed to step 6.
FIGURE 1. Roller Installation
FIGURE 2. Anti-jump blocks installation
3/4" (19 mm)
1/4"
(6.3 mm)
1/8” (3.5 mm)
Position rollers minimum
of 4” (101 mm) from edge
Drill Depth
XXX”
(XX mm)
Drill Depth
1"
(25 mm)
Position rollers 4"
(101 mm) from the edge
3/4" (19 mm)
1/4"
(6.3 mm)
1/8” (3.5 mm)
Position rollers minimum
of 4” (101 mm) from edge
Drill Depth
XXX”
(XX mm)
Tape Measure
Speed Square
HARDWARE MATCH UP GUIDE
Refer to the following full scale hardware
drawings to quickly match up the hardware.
# 10 x 2-1/2"
Wood Screws
5/16" (8mm x 90mm)
Track Mount Lag Bolt
5/16" (8mm x 60mm)
Carriage Bolt
Barn Door Installation Guide
BARN DOOR HARDWARE TOP MOUNT KIT
1-800-663-DOOR masonite.com
©2019 Masonite International Corporation. HMD-19028 TM