Measurement Guide

1
DOOR PREPARATION
STRAP INSTALLATION
Some models may not be pre-drilled
for mounting rollers. If needed, use a
3/8" dia drill bit to drill mounting holes
through the door using the strap as a
template. Install straps with roller on
the door with bolts provided using a
16mm & 17mm wrench. (FIGURE 1)
2
DOOR PREPARATION
ANTI-JUMP BLOCK INSTALLATION
Position each anti-jump block at least 1" from
the edge of the straps.
The hole for the anti jump blocks should be
offset from the center of the door so the
block can be rotated out of the way to be able
to hang the door on the track. (FIGURE 2)
NOTE: For concrete wall installation
proceed to step 3. For Drywall
installation proceed to step 6.
3/4" (19 mm)
1/4"
(6.3 mm)
3/8"
(10 mm)
Center to stile
or minimum
of 2" (51 mm)
2"
(51 mm)
3/4" (19 mm)
1/4"
(6.3 mm)
FIGURE 1. Roller Installation
16mm & 17mm Wrench
Tape Measure
Speed Square
5/16" (8mm x 90mm)
Track Mount Lag Bolt
# 10 x 2-1/2"
Wood Screws
Standard 1-3/16" Strap
Bolts
HARDWARE MATCH UP GUIDE
Refer to the following full scale hardware
drawings to quickly match up the hardware.
5/16" (8mm x 60mm)
Carriage Bolt
FIGURE 2. Anti-jump blocks Installation
Barn Door Installation Guide
FOR
1-800-663-DOOR masonite.com
©2022 Masonite International Corporation. RTL-22001
or
Adjustable Wrench
B
C
C
V STRAP KITS