Operating instructions

Masport F43/F28 Freestanding Gas Heater

Diagram 1

FRONT DOOR INSTALLATION

1) Open the two side panels.

2) Slide the door onto the two hinge pins making sure the two

pieces are flush together. See diagram 1.

3) Close the door. The latch plate must be centered around

the alignment pin. See diagram 2. If the latch plate

interferes with the corner of the stove you may want to

angle the plate slightly so the door closes easier.

Diagram 2 - F43

4) The latches should already be at the proper setting. If they

are too hard or too easy to close, you may want to adjust

them by loosening the latch catch. See diagram 3.

5) Remove the blue plastic protective coating from the

glass.

6) Test the seal around the door by placing a piece of paper

between the unit and the door, close the door and try to

pull the paper out. If it slips out easily, then the door is not

properly sealed. Tighten or loosen the latch. See diagram

Note: The door latch may require adjustment as the door

gasket material compresses after a few fires and

after glass replacement. Turn the latch catch in-

ward or outward to loosen or tighten.

Diagram 3 - F43

Diagram 2 - F28

Diagram 3 - F28

INSTALLATION