Service manual

G.Fire Service Manual 11 Issue A — © Masport, March 2004
4. For safety, strap the glasses together with a piece of adhesive tape at each top corner to prevent
them from falling out while the top trim is being fitted.
5. Slide the top trim into position under its guides and replace the two horizontal retaining screws.
Before tightening the screws, ensure that the three glass pieces are seated snugly against the top
glass tape to prevent any leakage. Do not over-tighten the screws.
6. Remove the adhesive tape and clean the glass.
7. Monaco. Assembly is the reverse of the above removal procedure. Clean the inside surface of the
glass and keep fingerprints off it as it is re-assembled.
8. Place the glass in position, noting that the bottom edge of the glass has no gasket.
9. Replace the left and right glass retainers, fitting their lower ends behind the bottom glass trim.
10. Slide the top glass trim into place, making sure the top ends of the side glass retainers are captured.
Fit the two fastening screws.
1.2.2 LOUVRE ASSEMBLY
1. Fit the slot at each end of the louvre assembly over its retaining post. For the Monaco, ensure that
the centre support plate engages its loop.
2. Press downward gently to engage the posts.
3. Confirm correct engagement by pulling forward on the louvre assembly.
1.2.3 DRESS GUARD (IF REQUIRED)
1. Cardrona. The front panel must be removed for fitting and removing the dress guard.
2. Angling the guard forward at the top, fit the two lugs at the top of the guard over the posts at each
end of the top of the glass assembly.
3. Swing the lower edge of the guard under the front glass support.
4. The guard is retained in position by fitting the front panel. (See 1.2.4)
5. Monaco. The guard simply clips behind the top and bottom edges of the glass retainers.
1.2.4 FRONT PANEL (Cardrona only)
1. Fit the keyhole slot at each end of the front panel over its retaining post.
2. Press downward gently to engage the posts.
3. Confirm correct engagement by pulling gently forward on the front panel.
4. Swing the front panel up into position and fix it there using the two clamp plates and screws
vertically from below.