Use and Care Manual

T-Boss550 OWNER’S/OPERATOR’S MANUAL 18.0
9. VEHICLE BREAK-IN PERIOD
9-1
The break-in period for your new UTV is defined as the first 50 hours of
operation. No single action on your part is as important as a proper
break in period. Careful treatment of new engine will result in more
efficient performance and longer life for the engine. Perform the
following procedures carefully.
CAUTION
Do not operate at full throttle or high speeds for extended periods
during the break-in period. Excessive heat can build up and cause
damage to close fitted engine parts.
1. Fill fuel tank.
2. Check oil reservoir level indicated on dipstick. Add oil if necessary.
3. Drive slowly at first. Select an area which is open and will give you
room to familiarize yourself with vehicle operation and handling.
4. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and all important
areas on the vehicle as outlined earlier on the daily pre-ride
inspection checklist found in” 4.daily pre-ride inspection ”.
6. Don’t pull loads.
7. Break in oil and filter. Change at 20 hours or 500 miles/800km.