Service manual

Section 4: Tutorial
4 - 12 Euphonix CS3000/2000 Operation Manual
As mentioned earlier, the two EQs may be linked together to form a stereo
pair. When in the EQ menu, press the [*ST] key on the Master Control Panel.
When stereo linked, both EQs are adjusted in tandem to give you a true stereo
4-band parametric. At any time you can unlink the two EQs by pressing the
[*ST] key again. When the two EQs are working in stereo, the SmartDisplay
indicates this with a “*”.
F3F1 F2 F4
In addition, the screen display indicates “Stereo EQ 1” instead of “EQ 1” on
the EQ title bar.
When you stereo link EQs by pressing the [*ST] key, all of the parameters of
the selected EQ are copied into the other EQ. For example, if EQ1 is selected
when you press the [*ST] key, EQ1’s curve is copied into EQ2. Likewise, if EQ2
is selected when you press the [*ST] key, EQ2’s curve is copied into EQ1.
Select EQ2’s source in a similar manner by pressing the EQ•Dyn 2 attention
key then the [M2] Source Dedicated Key. As before, this routing selection is
also seen in the far right of the SmartDisplay within the insert icon.
F3F1 F2 F4
The EQ may be switched in and out of circuit by pressing [F4] or by pressing
the rightmost of the 4 Function keys just below the Assignable Rotary Control
Set. (See the Introduction Section.)
This is our signal path now:
16E2–> lmG 0.0dB –>M2>-
16E2–> *lmG 0.0dB –>M2>-
Indicates stereo link
PWR
LF
PWR
STEREO 1 BUS
L R
M1
M2
BAL
4 Band EQ
4 Band EQ
Stereo Links
EQ2
EQ1
Signal path after
stereo linking EQs
PWR
LF
PWR
STEREO 1 BUS
L R
M1
M2
BAL
4 Band EQ
4 Band EQ
Stereo Link
EQ2
EQ1
Stereo Linking EQs
The Page 1 and Page 2
buttons on the DSC both
illuminate to indicate
when a pair of EQs is
stereo linked.
SIDE NOTE: