Specifications

ManualsBrandsMaster Chef ManualsGrilloutdoor Stovetop

WARNING

Failure to follow all of the Manufacturer’s

instructions could result in hazardous

fires, explosions, property damage, or

serious personal injury or even death.

WARNING

Follow all leak check procedures carefully

prior to operation of barbecue, even if

grill was dealer assembled. Do not try to

light this barbecue without reading the

Lighting Instructions section of this manual.

THIS BARBECUE IS FOR

OUTDOOR USE ONLY

WARNING

1. Do not store or use gasoline or other

flammable vapours and liquids in the

vicinity of this or any other appliance.

2. An LP cylinder not connected for use

shall not be stored in the vicinity of this

or any other appliance.

DANGER

If you smell Gas

1. Shut off gas to the appliance.

2. Extinguish any open flame.

3. Open lid.

4. If odor continues, keep away from the

appliance and immediately call your

gas supplier or your fire department.

Read and save this manual for future reference.

If pre-assembled, leave this manual

with unit for consumer’s future reference.

For product inquires, parts, and warranty and

troubleshooting support, please call 1-877-707-5463.

85-1603-8

G10601

Outdoor Stovetop

SAFE USE, CARE AND ASSEMBLY MANUAL

Summary of content (20 pages)

PAGE 1
Outdoor Stovetop S A F E U S E , C A R E A N D A S S E M B LY M A N U A L DANGER If you smell Gas 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. WA R N I N G 1. Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance. 2.
PAGE 2
WA R R A N T Y 1 Year Limited Warranty This Masterchef Outdoor Stovetop carries a 1 year limited warranty against defects in manufacturing workmanship. This Limited Warranty is nontransferable and becomes void if used for commercial or rental purposes. This warranty applies only when unit is used in Canada. The bill of sale or a copy will be required together with the serial number and model number when making any warranty claims from Trileaf Distribution.
PAGE 3
INFORMATION INSTALLATION ADDITIONAL WA R N I N G S The installation of this appliance must be in accordance with all local codes, or in the absence of local codes: • Canadian installation must conform to the current national standards, which at this time are CAN/CGA-B149.1/2-Natural Gas/Propane installation code.
PAGE 4
The Cylinder must also be equipped with: • A shut-off valve with a correct cylinder valve outlet as specified in current standards. • Canada: CAN/ CGA 1.6g-M97 Outdoor Gas Grills. • U.S.A: ANSI Z21.58a-2006/CSA 1.6a-2006 Outdoor Cooking Appliances. a) Constructed and marked in accordance with the Specifications for LP-Gas Cylinders of the U.S. Department of Transportation (D.O.T.
PAGE 5
FILLING THE L . P. C Y L I N D E R For safety reasons the LP gas cylinder, if supplied with your barbecue, has been shipped empty. The cylinder must be filled prior to use and must have the air purged. For safety, follow these instructions when having your cylinder filled: • Have only your local qualified LP gas dealer fill or repair a cylinder. • Do not overfill the cylinder beyond the safe 80% fill level. • Make sure the dealer tests and checks the cylinder for leaks after filling.
PAGE 6
Attention: Improperly lighting the barbecue can activate the flow control feature, resulting in lower heat output. If this occurs, the re-flow feature must be reset by turning off all the burner controls and the cylinder valve. Wait at least 30 seconds before slowly turning on the cylinder valve, and then after another 5 seconds turn the burner valve on and light the barbecue. Never connect this barbecue to an unregulated propane gas supply, or to another kind of gas.
PAGE 7
PRIOR TO USING Insert valve outlets into Venturi tubes approximately 6mm (1/4”) Drawing F NATURAL HAZARD SPIDERS Do not use your barbecue until you have carefully read and fully understand all the information in this manual. Please ensure the following: • Your barbecue is properly assembled. • There are no leaks in the system (see “Leak Test”).
PAGE 8
LIGHTING THE BARBECUE Prior to lighting your Outdoor Stovetop, visually check all hoses before each use, for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use your barbeque. A replacement hose and regulator is required. • Make sure you have followed all the checks, procedures and instructions in all previous sections before attempting to light the barbecue. Important Remove the lid before lighting the burner.
PAGE 9
Match-Lighting Do not lean over burner while lighting. 1. Remove lid. Turn on gas at LP cylinder. 2. Place lit match into match holder. Place match near burner. 3. Push in and turn burner knob to HI. Be sure burner lights and stays lit. WA R N I N G Use this slot for manual match lighting If the heat output is too low, the flow control feature may have been activated by a gas leak. If so, turn off the burner valve and cylinder valve, and perform the “Leak Test”.
PAGE 10
SAFETY CHECK Burner Check Light burner, rotate knob from HI to LOW. You should see a smaller flame in the LOW position than the HI position. Always check flame prior to each use. Burner Flame Check Inspect burner prior to each use. If burner is damaged do not use. Call manufacturer to purchase a replacement 1-877-707-5463 Ignitor Check Turn gas OFF at LP cylinder. Depress the ignitor knob. “Click” should be heard and spark seen each time between burner and electrode.
PAGE 11
TROUBLESHOOTING GUIDE Problem Burner will not light (match or igniter) Possible Causes Corrective Action • Blocked venturi tubes • Clean out blockage • Cylinder or gas supply valve turned off • Open cylinder or gas supply valve • Venturi tubes not properly sealed over valve igniter electrodes • Ensure proper venturi tube assembly • Burner ports blocked • Clean/replace burner • Low or out of propane • Refill cylinder • Flow control device activated • Follow correct lighting procedu
PAGE 12
PARTS LIST 85-1603-8 10 (G10601) Item No. Quantity Description Part No.
PAGE 13
Manual Hardware Pack DF DE CP 11
PAGE 14
A S S E M B LY I N S T R U C T I O N S Hardware Pack List Key No. Description 1 No.10-24 UNC x 25 Screw 20124-10025-03A 6 2 ø5 Washer 40300-05000-250 9 3 ST4.2 x 10 Tapping Screw 22500-42010-13A 24 4 No.8-32UNC x 10 Screw 20132-08010-032 2 5 ø4 Lock Washer 41400-04000-250 2 6 1/4"- 20 UNC Flange Nut 31220-13000-03A 2 7 No. 10-24 UNC Flange Nut 31224-10000-03A 3 8 No. 8-32UNC x 25 screw 20132-08025-250 2 Grill is heavy.
PAGE 15
1 Insert 3 vertical supporting bars (CH) into tank support (DA). Secure the supporting bars to the tank support using hardware #1 (x6) and #2 (x6). 2 Assemble the side panel (CF), front panel (CE) and supporting bars (CH) together as shown using hardware #3 (x16). 3 Assemble the igniter (CB) to the control panel (CA) as shown. Assemble the burner valve (CD) to the control panel (CA) using hardware #8 (x2) and #5 (x2) as shown.
PAGE 16
4 Position the control panel (CA) into the hole located on the front panel (CE) using hardware #3 (x4). Place the control knob (CC) on as shown. 5 Assemble the cart handle (CJ) to the side panel (CF) using hardware #6 (x2) as shown. 6 Assemble the Bracket Holder (CK) to the bottom of Heat Shield (BE) using hardware #11 (x2) as shown. Fix the Tank Retention Bracket (BL) to the bracket (CK) using Wing Screw (CO) with hardware #12 (x1) as shown.
PAGE 17
7 7.1 Assemble the burner assembly (BC) to the heat shield by positioning the burner Venturi tube through the hole located in the heat shield, using hardware #7 (x3). 7.2 Assemble the heat shield and burner to the top of the cart body using hardware #3 (x4). 8 Connect the electrode wire to the igniter (CB) as shown. VERY IMPORTANT Burner Venturi tubes must engage valve openings. Make sure the valves are aligned with burner Venturi tubes.
PAGE 18
10 Assemble the back panel (CG) by attaching to the heat shield as shown. Then place lid to cover the top of this unit. CAUTION Lid should only be used for storing after Side burner unit has cooled down. Never place cover over burner when unit is in operation. 11 LP CYLINDER IS SOLD SEPARATELY. Fill and leak check the cylinder before attaching to the grill and regulator. Once the cylinder has been filled and leak checked, place cylinder into the bottom of the cart cabinet.
PAGE 19
12 Remove one of the hardware #3 (self tapping screw) from the Front Panel (CE), then connect the Retention Hook to the Front panel (CE) as shown using the same hardware which was just removed (hardware #3) and a 5mm washer (hardware #2). Important! Clip the regular PVC hose to the hook as shown before connecting the QCC1 regulator to the gas tank. WA R N I N G This step must be followed to prevent the regulator hose from getting damaged.
PAGE 20
DISTRIBUTOR Trileaf Distribution Trifeuil Toronto, Canada M4S 2B8