Installation Instructions

MW01 QUICKSTART
ON
The first time you power ON the MW01 it will automatically
enter pairing mode. To manually activate pairing mode, leave
the MW01 in the extended position for 5+ seconds and look
for the pairing indicator light. Once in pairing mode, activate
pairing mode on your earphones or headphones and place
them adjacent to your MW01.
PAIRING INDICATOR
• A pulsing white light indicates
the MW01 is in pairing mode.
• A solid white light indicates a
device is connected.
To Power ON, pull the MW01 into the extended position.
HIGH MED
LOW
BATTERY INDICATOR
Battery Indicator light is only
shown when powering ON/OFF
or charging the MW01.
OFF
To power OFF, tuck away the
prongs and retract the MW01.
If no headphones or earphones
are connected, the MW01 will
power OFF in 10 minutes.
MW01會自動連接到先前連接的耳機。選擇需要連接到
您預期裝置的插針數量。如果使用單插針連接，則僅
使用標記為「1」的插針。
S
ymbol instruction:
D
C voltage
R
ECYCLING
T
his product bears the selective sorting symbol for Waste electrical and electronic equipment
(
WEEE). This means that this product must be handled pursuant to European directive
2
012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
U
ser has the choice to give his product to a competent recycling organization or to the retailer
w
hen he buys a new electrical or electronic equipment.
W
arning
-
Don’t disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a
b
attery, that can result in an explosion;
–
Don’t leaving a battery in an extremely high temperature surrounding environment that can
r
esult in an explosion or the leakage of flammable liquid or gas;
–
Don’t leaving a battery subjected to extremely low air pressure that may result in an explosion
o
r the leakage of flammable liquid or gas.
C
AUTION
Risk of explosion if battery is replaced by an incorrect type.
F
CC STATEMENT
T
his device complies with part 15 of the FCC Rules. Operation is subject to the following two
c
onditions:
(
1) This device may not cause harmful interference, and
(
2) This device must accept any interference received, including interference that may cause
u
ndesired operation.
W
ARNING: Any changes or modifications to this unit not expressly approved by the party
r
esponsible for compliance could void the user’s authority to operate the equipment.
N
OTE: This equipment has been tested and found to comply with the limits for a Class B digita
l
d
evice, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
p
rotection against harmful interference in a residential installation. This equipment generates
u
ses and can radiate radio frequency energy and, if not installed and used in accordance with
t
he instructions, may cause harmful interference to radio communications.
—
Reorient or relocate the receiving antenna.
—
Increase the separation between the equipment and receiver.
—
Connect the equipment into an outlet on a circuit different from that to which the receiver is
c
onnected.
—
Consult the dealer or an experienced radio/TV technician for help.
T
he device has been evaluated to meet general RFexposure requirement. The device can be
u
sed in portable exposure condition without restriction. The device has been evaluated to mee
t
g
eneral RF exposure requirement. The device can be used in portable exposu re conditio
n
w
ithout restriction.
I
C STATEMENT
T
his device contains licence -exempt transmitter(s)/receiver(s) that comply with Innovation,
S
cience and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to
t
he following two conditions:
(
1) This device may not cause interference.
(
2) This device must accept any interference, including interference that may cause undesired
o
peration of the device.
L
e présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
e
xempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(
1) l'appareil ne doit pas produire de brouillage, et
(
2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
b
rouillage est susceptible d'en compromettre le fonctionnement.
R
adiation Exposure Statement: The product comply with the Canada portable RF exposur
e
l
imit set forth for an uncontrolled environment and are safe for intended operation as describe
d
i
n this manual.
D
éclaration d'exposition aux radiations : Le produit est conforme aux limites d'exposition pour
l
es appareils portables RF pour les Etats -Unis et le Canada établies pour un environnement
n
on contr?lé.
H
owever, there is no guarantee that interference will not occur in a particular installation. If thi
s
e
quipment doe s cause harmful interference to radio or television reception, which can be
d
etermined by turning the equipment off and on, the user is encouraged to try to correct th
e
i
nterference by one or more of the following measures:
MW01
Insert Card (Quick Start – Int.)
2020.05.08
Double-Sides, Tri-fold Card
100%
Matte coated
Bright white