Instructions / Assembly

Master Flow

EmberShield

Closeable Soffit Vent

Installation Instructions

(Figure 1)

Important: During installation, always wear appropriate safety glasses, gloves, hard hats, fall

restraints, and other safety equipment to avoid injury.

Step 1: Cut a 15” x 7.5” (391 mm x 191 mm) opening in the soffit or remove existing soffit vent. If

replacing an existing soffit vent, ensure the vent is no larger than 16” x 8” (406 mm x 203 mm).

Step 2: Center the EmberShield

Closeable Soffit Vent over the opening, making sure it is square

with the structure. Fasten in place through the holes in the vent with four included screws (Figure 1)

Step 3: If painting (not required), do not paint the screen or slider portion of the vent. After paint

dries, always ensure proper movement of the slider.

Step 4: During threat of wildfire, fully close the EmberShield

Vents to help prevent embers from

being drawn into attic. Otherwise, the vents must always remain open for proper attic ventilation.

If the EmberShield

Closeable Soffit Vents are located at hard-to-reach locations, it is recommended

that an extension pole (typically used for painting) be used to open and close the vents.

Note: It is recommended that you periodically open and close the vents to ensure they are

functioning properly.

Note: Always have a balanced attic ventilation system. In no case should the amount of exhaust

ventilation exceed the amount of intake ventilation. Always consult local building codes for other

ventilation requirements.

For technical assistance, please call GAF Master Flow

at 1-800-211-9612