Instruction manual

22
Lowes.com/masterforge
CONVERSION INSTRUCTIONS
Conversion Instructions for Item #0221886/
#0006554
1. Take the burners out and adjust the air
shutter.
a. Main Burner Conversin
Pull off the R-pins and take the main
burners out. Adjust main burners’ air
shutters by loosening the air shutter
screws. (Fig. 56)
b. The settings are:
1/4 in. open for LP gas.
1/16 in. - 1/8 in. open for NG gas.
You need to adjust the openings before you
put the burners back in the burner box.
(Fig. 57)
2. Change to NG orices
a. Remove the LP orices rst with the orice
removal tool (B), then install the NG orice.
Make sure you are using the correct
orice, marked “1.37”. (Fig. 58)
3. Sear Burner Conversion
a. Remove the grid and drip tray from the sear
burner.
b. Remove the 2 screws (1/4-20 x 1-3/8 in.)
from the left side of the sear burner box.
The screws are located inside of the main
burner box. (Fig. 59)
56
R-pin
bracket
main burner
air shutter
57
58
B
1.37
59