Instruction manual

27
Lowes.com/masterforge
CONVERSION INSTRUCTIONS
2. Side Burner Conversion
a. Take the side burner grate and burner
heads off. Separate the side burner ignition
wire at the connect (Fig. 73a) and then
disassemble the side burner body by
removing the three screws as shown in
(Fig. 73b)
b. Use two wrenches to remove the side
burner nozzle from the side burner valve.
Then install the NG nozzle to the valve.
This nozzle is packed in the #0404349
hardware pack. The size is 1.55. (Fig. 74)
Note: Failure to use two wrenches to
loosen or install the nozzle may damage
the valve. The valve stem needs to be
protected.
Side burner nozzle
74
73b
Three screws
Connect the ignition
73a