Instruction manual
35
Lowes.com/masterforge
CONVERSION INSTRUCTIONS
WARNING: Please remember this is an outdoor gas grill. Many areas of the grill
generate extreme heat. We have taken every precaution to protect you from the
contact areas. However, it is impossible to isolate all high-temperature areas.
Therefore, use good judgment and a certain degree of caution when grilling on this
product. We suggest a covered, protected hand during operation of grill. Do not move
the grill when it is in operation or hot to the touch. Wait until the unit is turned off and
properly cooled down before moving it. Failure to follow this warning could result in
personal injury.
Do not operate the gas grill indoors or in any enclosed area. If the gas grill is not in use, the
gas must be turned off at the supply tank. If the grill is to be stored indoors, disconnect the
gas supply hose.
When checking for gas leaks, do not use an open ame. Use a soapy water solution and
apply it to the pipe joints and ttings with a brush and check for bubbles. Check exible hoses
for cuts and wear that may affect the safe operation of the grill. Only the factory supplied
hose must be used. Use only replacement hose assemblies specied by manufacturer.
Checking Gas Leaks
WARNING: Never use a match or open ame for leak detection. Use of an open ame
could result in a re, explosion and bodily harm.
IMPORTANT: When connecting or replacing any gas pipe or ttings, all joints must be
sealed with approved leak-proof sealing compound or plumber's tape.
Never store a spare tank under or near your grill.
IMPORTANT: When connecting or replacing gas pipe or ttings, all joints must be
sealed with approved leak-proof sealing compound or plumber's tape. After making
connections, check all joints for leaks using a soapy water solution and a brush.
WARNING: Never use an open ame to test for gas leaks. Use of an open ame could
result in a re, explosion and bodily harm.
Before operating the grill, after refueling, check carefully to be certain that all
connections are tight and there are no gas leaks.
1. Make 2-3 ounces of leak solution by mixing liquid dishwashing soap with water.
2. Make certain all control knobs are in the “OFF” position.
3. Brush small amounts of the leak solution on all the ttings and turn the gas on.
4. If bubbles appear, there is a leak. Proceed to step 5.
5. Turn the gas off and tighten all connections.
6. Go back to step 1 to retest the ttings.
7. If bubbles continue to appear, turn the gas off. Contact customer service.
21