Instruction manual

36
Lowes.com/masterforge
CONVERSION INSTRUCTIONS
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
Grill or side cooker
will not light
1. The ignition system is not
properly installed.
2. The ignition wire is
broken.
3. The battery has died.
4. The battery is in the
wrong polarity.
5. The electrode tip does
not produce sparks at the
burner port.
6. No gas supplied.
7. Air shutter opening is too
big.
1. Reinstall the ignition system and make
sure the sparks produced close to the
burner ports or close to the infrared
burner ceramic surface.
2. Call customer service for a replacement
ignition wire.
3. Install a new AA battery.
4. Change the battery polarity.
5. Reinstall the electrode.
6. Turn on the regulator valve.
7. Loosen the air shutter and adjust the
opening to a smaller size.
Burner ame is
yellow and gas odor
can be smelled
1. The air shutter opening
is not properly set.
2. Spiders or insects block
the air shutter.
3. There is a gas leak.
1. Loosen the air shutter and adjust the
opening to have blue ames.1/8 in. or
less opening for NG.
2. Clean blockages.
3. Check for the source of gas leaks.
Low heat with the
knob in “HIGH”
position
1. Natural gas pressure is
low.
2. Installed with the wrong
nozzles.
3. Burner ports are blocked.
1. This model is set for 7 in. natural gas
usage. Please check your natural gas
supply system to have correct gas
pressure. Regulator is not needed for
NG conguration.
2. Check to see if you installed the correct
orices. See page 3 for orices sizes.
3. Clear burner ports of any obstructions.
Low heat, natural
gas
Gas pressure is signicantly
affected by gas line and
length of gas line from
house gas line.
Check your gas line and make corrections
by following the chart below.
From House to Grill
Distance Tubing Size
Up to 25 ft. 3/8 in. diameter
26 ft.-50 ft. 1/2 in. diameter
51 ft.-100 ft. 2/3 in. of run 3/4 in.
1/3 in. of run 1/2 in.