Instruction manual
9
Lowes.com/masterforge
CONVERSION INSTRUCTIONS
Adjust valve model control screw
1. Pull all the knobs off from valve stems.
(Fig. 18)
2. Adjust the screw in each valve hole using
the athead screwdriver (C).
In NG conguration turn the screws
clockwise until tightened. (Fig. 19)
Make sure to completely tighten the
screws. Failure to tighten the screws will
result in the low heat setting working
improperly. (Fig.19)
18
19
valve hole
To complete adjustment, press all the knobs onto valve stems. After making all of the
conversions, return heat tents to burner box, followed by the grid and warming rack.