User's Manual

Master Lock Company LLC, Milwaukee, WI 53154 U.S.A. | 800-574-7260

6 P57672 REV A

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

Warning: Any modification without the express written consent of The Master Lock Company LLC could void

your authority to operate this product and invalidate the product warranty.

Model 27213 Bluetooth Keypad

The 27213 Bluetooth Keypad is an access control keypad reader that is part of the Master Lock Bluetooth family of products. The

Keypad works with the 27219 and 27220 Door Controllers to provide entry at shelters, cabinets and others equipped with Master Lock’s

high-security electromechanical locks. Devices are managed within the Master Lock Vault Enterprise Access Control System (ACS)

and use credentials issued by (ACS,) including Temporary Access Codes (TACs) for manually entered or mobile credentials from the

Master Lock Vault Enterprise Bluetooth mobile app.

These elements of the system function together to provide convenient and simple access control and management without requiring a

real-time network connection with the ACS Host.

General Capabilities

Access is granted through use of the Master Lock Vault Enterprise App (App) installed on a Bluetooth 4.0 capable-device or a manually

entered Temporary Access Code (TAC) at the Keypad. When the Keypad communicates a valid credential to the Door Controller, the

controller sends power to unlock the locks. The Door Controller stores transaction data, which is also uploaded to ACS by the App

through the Keypad’s Bluetooth connection.

The Keypad is also used to deliver firmware and configuration updates to the Door Controller. The Keypad provides information about

errors and battery status via its LED indicator. The Keypad LED status is mirrored on an indicator on the Door Controller board.

The Keypad offers a battery jump port that provides a connection for a 9V battery to supply power to the Door Controller if all other

power sources have become unavailable.

Preparation and Installation

Keypad Installation (Direct Mounting)

Measure

1. Identify the desired vertical height for your installation.

(Note: Ensure compliance with regulations and guidelines

for accessibility)

2. Refer to the keypad mounting dimensions on pg 3 to mark

the mounting holes and keypad cable through-hole on the

mounting surface. Center punch all marks.

3. Using the center mark, create a 5/8” opening for the

keypad cable through-hole using a drill and step bit.

4. Drill (4) 7/32” (.218”) holes in the punched locations

completely through the door to the other side.

NOTE 1: Grommets of 5/8” diameter are provided to

protect the cable from sharp edges. Insert a grommet in

both sides of the cable through-hole if desired.

NOTE 2: Access to both the front and back of the

mounting surface is necessary for this mounting method.

Install (4) #10-32 studs of appropriate length into the mounting

holes on the back of the Keypad (not provided)

Keypad Gasket

Bluetooth Keypad

Studs

Keypad Gasket