Programming instructions

ManualsBrandsMaster Lock ManualsDoorE72

Security Door Controls

3580 Willow Lane, Westlake Village, CA 91361-4921 • (805) 494-0622 • Fax: (805) 494-8861

www.sdcsecurity.com • E-mail: service@sdcsecurity.com

PROGRAMMING INSTRUCTIONS

E72K-A CIVIC SERIES

160 User Electronic Digital Door Lock

P:\INSTALLATION INST\ELECTRIFIED LOCKSETS/INST-E72K-A/INST-E72K-A.vsd REV - 07-08 Page 1

Any suggestions or comments to this instruction or

product are welcome. Please contact us through

our website or email engineer@sdcsecurity.com

Summary of content (7 pages)

PAGE 1
Security Door Controls 3580 Willow Lane, Westlake Village, CA 91361-4921 • (805) 494-0622 • Fax: (805) 494-8861 www.sdcsecurity.com • E-mail: service@sdcsecurity.com PROGRAMMING INSTRUCTIONS E72K-A CIVIC SERIES 160 User Electronic Digital Door Lock P:\INSTALLATION INST\ELECTRIFIED LOCKSETS/INST-E72K-A/INST-E72K-A.vsd REV - 07-08 Page 1 Any suggestions or comments to this instruction or product are welcome. Please contact us through our website or email engineer@sdcsecurity.
PAGE 2
IMPORTANT KEYS: TERMINATOR KEY ( ) * Acts like the “Enter” key on a computer, and is used to confirm entries on the keypad. PROGRAMMING KEY (#) After a valid Master Code is entered, this key is depressed to enter the programming mode. NOTE: At the end of any programming series, replace the last with a # to return to function number input. This allows the programmer to perform multiple functions without having to re-enter the Master Code for each function.
PAGE 3
PIN ONLY ENTRY The PIN only mode will shorten the code required to open the lock. * TO OPEN LOCK) 32 * ENABLE (PIN Enter MASTER CODE # 0 * * * * * DISABLE (USER ID & PIN TO OPEN LOCK) Enter MASTER CODE # 32 * 1 CHANGE USER PIN This function gives the users the ability to change their PIN (user must know their User ID & PIN to perform this function).
PAGE 4
MANUAL PASSAGE MODE This function puts the lock in an unlocked state, granting free egress (no code required) to all Users until the lock is returned to the locked state. Returns to locked state at midnight and requires that the time be set (see “Set Time” below). ENABLE # Enter MASTER CODE 30 * 1 * * * 0 * * DISABLE # Enter MASTER CODE 30 TEMPORARY USER SCHEDULE This function allows you to restrict an existing Users’ access by a date range.
PAGE 5
PRIVACY MODE/SECRETARY MODE An E72K-A with the Privacy Mode option (Secretary Mode is default) will have a button installed on the inside housing. When the button is pressed it will block out keypad entries (except User Codes from groups 01-03). When the inside lever is pressed the request to exit switch will reset the keypad back to normal operating mode.
PAGE 6
BATTERY INFORMATION THE E72K-A IS SHIPPED WITH 4 “AA” ALKALINE BATTERIES: The life span has been tested in two different ways. The first test was performed to see how many operations could be performed repeatedly before a failure. The test averaged 150 thousand operations. The second test was performed over time for normal operations. This test revealed the the E72K-A batteries would last approximately 4 years at 80 -90 thousand operations.
PAGE 7
User Number Name Group Number PIN Code P:\INSTALLATION INST\ELECTRIFIED LOCKSETS/INST-E72K-A/INST-E72K-A.