Product Manual

320.340.6464
6
OPERATION - IMPORTANT SAFETY INFORMATION
Now that you have assembled your sprayer, there is some important safety
and health information you need to know with regard to handling and
spraying chemicals.
TAKE NOTE! THIS SAFETY ALERT SYMBOL FOUND THROUGHOUT
THIS SECTION IS USED TO CALL YOUR ATTENTION TO
INSTRUCTIONS INVOLVING YOUR PERSONAL SAFETY AND THE
SAFETY OF OTHERS. FAILURE TO FOLLOW THESE INSTRUCTIONS
CAN RESULT IN PROPERTY DAMAGE, INJURY OR DEATH.
GENERAL CHEMICAL SAFETY
WARNING
Pesticides are hazardous chemicals. Heed the warning below and follow
all instructions carefully. Improper handling of chemicals can result in
serious injury or illness, or cause damage to humans, animals or the general
environment.
NOTE: THE USE OF CORROSIVE OR FLAMMABLE
CHEMICALS IN THIS SPRAYER IS HAZARDOUS AND WILL
ALSO VOID YOUR WARRANTY.
TOOLS
PARTS
Connect Wire Harness to 12v Diaphragm Pump by pushing the
two-pin terminal connectors together.
Connect the red clamp to your battery’s positive post and the black
clamp to the negative post.
Connects Sprayer to Battery
10.
None
NOTE: Connecting wire
harness clamps to opposite
posts will cause the Pump to
run backwards.
SPOT SPRAYER ASSEMBLY
TOOLS
PARTS
Wrap a small amount of Teflon Tape around the threads of the
Pressure Gauge.
Screw the Pressure Gauge into the top of the Pressure Regulator
Assembly. Take care not to cross-thread the Pressure Gauge.
Installs Pressure Gauge
9.
NOTE: Make sure Pressure
Gauge is well seated, being
careful not to over tighten.
Make sure Pressure Gauge’s
front is facing forward with
Pressure Regulator knob.
T
E
F
L
O
N
T
A
P
E