Product Manual

320.340.6464
8
PREPARING SPRAYER
• Review Safety Information: Review safety information in this manual
and manufacturer chemical label before use.
• Sprayer Attachment: Ensure the sprayer is securely attached to the
vehicle.
• Empty Tank: Ensure the sprayer has been thoroughly flushed and
drained of all residual chemical prior to uses.
• Clean Suction Strainer: Clean suction strainer of any chemical residue
with fresh water. USE RUBBER GLOVES for extra safety.
• Inspect & Test: Inspect the tank and components for any cracks or
leaks. Replace any damaged parts. IMPORTANT: After any repair, ALWAYS
test for leaks with water one final time before use.
• Check Drain Cap: Before filling tank, ensure drain cap at bottom of tank
is securely tightened.
• Protective Equipment: ALWAYS wear protective equipment as directed
on the chemical label.
• Assess Wind & Area Conditions: Before spraying, determine if wind
conditions are suitable. DO NOT spray if wind speeds are greater than 4
MPH. DO NOT spray if bystanders are in the intended area and verify that
area is in a well-ventilated outdoor area.
• Power Off: Before filling tank, make sure power to the sprayer and the
vehicle is off and brakes are set to prevent unintended movement.
• Filling Tank: Remove sprayer tank lid and add chemical/water dilatation
ratios that are called out by chemical label. Ensure chemical is thoroughly
mixed with a stirring device and then securely thread tank lid back on
sprayer tank.
USING SPRAYER
SPOT SPRAYING
• Spot Spraying: To spot spray, pull the gun trigger. Make sure nozzle of
gun is pointed towards vegetation in need of spraying.
• Adjustable Nozzle: Twist the spray nozzle to adjust from a straight
stream to wide pattern mist.
Note: It is not unusual for the operator to be exposed to chemical drips
while adjusting the nozzle – use chemical resistant gloves when twisting.
BROADCAST SPRAYING
• Open Boom Valve: Open up boom valve to allow flow from tank to
boom kit.
• Ensure Correct Pattern: Make sure boom nozzle is pointed straight
down. If not, loosen the nozzle retaining nut and adjust orientation of the
boom nozzle opening to point straight down.
Note: It is not unusual for the operator to be exposed to chemical drips
while adjusting the broadcast nozzle. Chemical resistant gloves should be
worn.
• Open Boom Valve: Open up boom valve to allow flow from tank to
boom kit.
• Uniform Coverage: To ensure proper coverage, follow the separate
boom kit manual that came with your sprayer.
• Broadcast Spraying: Turn the remote switch to the “ON” position to
being spraying.
• Broadcast Boom Valve: Close broadcast boom valve to prevent
acci
dental spray release.
• Turn On Power: Connect the wire harness to vehicle battery and
turn the remote switch to the “On” position.
USING SPRAYER (CONTINUED)