Product Manual

320.340.6464
9
• Drain Tank: If there is excess pesticide left in tank, drain into a suitable
container.
Note: when draining pesticides, be sure to wear protective gear such as
rubber gloves and eye protection for increased safety.
• Unused Chemical: Properly store or dispose of unused chemical in its
original, suitable container and make sure to follow chemical manufacturer’s
recommendations and according to local hazardous waste disposal regulations.
• Flush Sprayer: Flush sprayer per the chemical manufacturer’s
recommendations.
• Decontaminate & Launder: Decontaminate yourself after handling
chemicals by removing clothing worn, washing exposed body parts with soap
and water, and laundering clothing separately from other wash.
CLEANING & DECONTAMINATING SPRAYER
• Add Anti-Freeze: Pour one gallon of RV anti-freeze into the sprayer tank.
• Spray Briefly: Turn on the pump motor and squeeze the gun trigger briefly
until fluid sprays out.
PREPARING SPRAYER FOR STORAGE
WARNING
Clean-up and decontamination procedures must be followed after each use.
Improper equipment clean-up and disposal of chemicals can result in
dangerous chemical exposure to humans and the environment, as well
as equipment damage.
Personal decontamination is required after spraying to minimize unsafe
exposure to chemicals and potential illness.
SPRAYER STORAGE
Prepare the sprayer for end-of-season storage by running RV anti-freeze through
the system. This will keep internal parts lubricated, protect against corrosion, and
keep the unit from freezing.
OPERATION - CLEANING, DECONTAMINATING & STORAGE
When done using the sprayer, it is always important to clean the sprayer and
decontaminate yourself. Do not store the sprayer with chemicals in the tank, as it
is unsafe and could also result in damage.
WARNING
The sprayer will be damaged if it freezes.
Protect the sprayer from freezing during storage by following instructions
below.
• Drain Anti-Freeze: Drain the anti-freeze that is left in the tank through the
tank drain port into a suitable container.
• Flush with Water: Fill tank with fresh water and have it run through system.
Operate spray gun and boom until the system is completely flushed. Be sure to
set up containers to capture the flushing of the anti-freeze.
• Disposal: Dispose of anti-freeze and flush water properly.
REMOVING SPRAYER FROM STORAGE
IMPORTANT NOTE:
ALLOWING YOUR SPRAYER TO FREEZE, WITHOUT TAKING
PROPER WINTERIZATION STEPS, VOIDS YOUR WARRANTY.