Owner`s manual

America’s Leader In Luxury

MASTER SPAS

MASTER SPA

Filtration Cycle Programming for LSI557 only

The first filter cycle ("day") begins 6 minutes after the spa is powered up.

The second filter cycle ("night") begins 12 hours later. Filter duration is

programmable for 1 - 12 hours (F1 - F12). The default filter time is 2 hours.

To program, press "Warm" or "Cool" then "Jets 1". Press "Warm" or "Cool" to

select the filter duration. Press "Jets 1" to select the number of filter cycles.

The display will show "dn" (both "day" and "night" cycles); "d" (day cycle only);

or "n" (night cycle only). Press "Warm" or "Cool" to adjust, then press "Jets 1"

to exit the programming mode. For continuous filtration, use F12 and "dn".

Clean-up Cycle

When the pump is turned on by a button press, a clean-up cycle begins 30

minutes after the pump is turned off or times out. The pump and the ozone

generator will run for one hour.

Ozone

The ozone generator runs during normal circ pump operation. Your system is

configured with the ozone disable feature, the ozone generator will turn off for 1

hour any time a function button (Jets 1, Jets 2, Jets 3, etc.) is pressed.

Freeze Protection

If the temperature sensors detect a drop to 44˚F (approximately 6.7˚C) within

the heater, then the pump automatically activates to provide freeze protection.

The equipment stays on until 4 minutes after the sensors detect that the spa

temperature has risen to 45˚F (approximately 7.2˚C) or higher.

Locking the Panel (PL - see page 36 under Indicator Light)

Press "Time" "Jets 1" then "Warm" within 3 seconds. When locked, the PL indi-

cator light will light. All buttons are frozen except the "Time" button. To unlock

the panel, press "Time" "Jets 1" then "Cool" within 3 seconds.

Locking the Set Temperature (TL - see page 36 under Indicator Light)

Press "Warm" or "Cool" then "Time", "Jets 1", and "Warm" within 3 seconds to

activate the lock. The TL indicator light will light when the set temperature is

locked.

To unlock the set temperature, press "Warm" or "Cool" then "Time", "Jets 1"

and "Cool" within 3 seconds.

MS Owners Manual 12/5/03 2:04 PM Page 38