Owner`s manual

DELUXE FUSION AUDIO SYSTEM

Warning: Never remain in your spa longer than 15 minutes per session when the

water temperature is above 98˚F. If you wish to spend more time in your spa,

whether enjoying music, or just lounging, be sure to keep the spa water at or

below body temperature (98.6˚F).

*Please refer to your stereo Owner’s Manual for specific operations.

Optional Stereo Docking Station

Your spa is equipped with an iPod™ docking station that will allow you to listen to personal

selections through the audio system of the spa. This audio system also has an FM only radio

receiver that can be used to listen to local FM broadcasts. Due to varying signal conditions the

FM radio reception may be limited.

The docking station is compatible with most iPod™ products. Master Spas, Inc. does not

guarantee compatibility with all iPod™ products due to software changes and upgrades.

The wireless remote provided with the spa is water resistant, but should never be left in the

spa when not in use.

Remote Synchronizing

1. Turn the docking station OFF with the on/off button inside the door

(the red LED should not be illuminated when power is OFF).

2. Press the red (POWER) button on the remote.

3. Turn the docking station ON with the on/off button inside door (the red LED will illuminate

when power is ON).

4. Press and hold the (MODE) button on the top right corner. Hold for 10 seconds.

5. The remote’s LCD should read WELCOME or show a mode position such as RADIO, IPOD,

or AUX IN.

If the pairing process is not effective, turn the docking station OFF with the on/off button,

located inside the door of the dock. Uplug the 12-pin harness on the back of the stereo for 3

minutes. Reattach the harness and repeat steps 1-5 above.

If the LCD displays “- -” in either mode, this means that your remote control is out of recep-

tion range. Please move closer and try the feature again.

Each Digital Media Locker™ comes with a matching RF (Radio Frequency) Wireless LCD

remote control. This remote is required to use any functions on the unit. For any additional

remote controls you will need to activate/synchronize those remote controls to the AQ-DM-4

by following the steps above.

If you lose your remote control and buy a replacement, follow the steps above to pair/syn-

chronize before normal usage.