Owner`s manual

OPERATION INSTRUCTIONS
The only user controllable components are jet pumps 1, 2, e-stop/timer, and the Wave
propulsion system.
E-STOP
The E-stop is installed to allow for quick power down should an emergency arise in or
around the spa. Simply pressing the e-stop will cut power to the jet pumps, filter pump,
and propulsion system until the e-stop is reset. The E-stop can be reset by twisting the
button counter clockwise.
*Never use the e-stop as a maintenance system shutoff, or for any reason other than an
emergency. Should the need to shut the unit down arise, the main input power breakers
should be used as a means of completely disconnecting power.
Jet Pump 1, Jet Pump 2
These components are controlled by the e-stop and timer. To turn on, simply confirm that
the e-stop button is not tripped, and then turn the timer to the desired time (15 minutes max).
After 15 minutes, the jet pumps will automatically turn off.
Light
Spa light shall be controllable from the equipment room only and shall not be accessible to
occupants. Operation of lights shall be on continuously.
Exception: Should local authority having jurisdiction allowed for it, the light may be turned off
during hours when spa is not open to the public.
Wave Propulsion System
The Wave propulsion system works off of the control panel located on the end of the spa
opposite of the entry steps (see figure 1). This panel is designed with simple operation in
mind. The swim number system allows the user to easily identify what setting they are
using during training. These numbers range from 0-60 so that a favorite setting can always
be repeated easily. The Swim Number System allows the user to easily increase the speed
of water flow by either gradually pressing the “SPEED UP/ON” button or by holding it down
to achieve the desired Swim Number. To decrease the speed of the water flow press the
“SPEED DOWN/OFF” button until the desired speed is reached. To completely turn off the
system, press and hold the “SPEED DOWN/OFF” button for 7 seconds before releasing it.
The system has an automatic shut-off feature that will turn off the propulsion system after
30 minutes of continuous use.
Figure 1
10