Owner`s manual

TYPICAL WORK INVOLVED FOR INSTALLATION OF MASTER SPAS SPA
17
PLUMBING CONTRACTOR INSTALLATION
Provide all materials, equipment and labor needed to fulfill requirements set forth in the
owner’s contract. Install all interconnecting plumbing between the spa and the spa equipment
as per the “Technical Drawings” section of this manual, and as required by the local regulatory
authority having jurisdiction.
Install proper drains for maintenance and overflow. Provide drains in the sump area (if appli-
cable), floor drains in the spa room and also a gravity drain(s) capable of handling the portable
sump pump used to drain the spa.
All of the valves, fittings, etc. shall be NSF-50 or equivalent approved, all piping shall be at
minimum schedule 40 NSF-50 or equivalent approved PVC attached with appropriately rated
glue.
When the electrical contractor has confirmed operation of the motors and associated equip-
ment, the spa is to be filled and all plumbing installed on site hydrostatically tested as required
by the local regulatory authority having jurisdiction.
MECHANICAL CONTRACTOR INSTALLATION
Provide all materials, equipment and labor needed to fulfill requirements set forth in the
owner’s contract. This will be done to satisfy conditions identified in the installation guide so
as to provide proper ventilation, heating, dehumidifying, and air conditioning of the spa room.
This also must be done in accordance with all applicable codes.
INITIALIZATION REQUIREMENTS
Electrical Contractor:
• Confirm power to systems.
• Before spa is filled confirm that all systems wiring conforms to installation guide wiring sche-
matics and all local and state electrical codes.
Plumbing Contractor:
• Confirm that all floor drains and sump pump(s) (if applicable) are fully operational
• Confirm that all plumbing is installed and conforms to proper configurations and that all
valves are in the correct positions.
• Confirm that there are no leaks in the system.
General Contractor:
• Clean and fill the spa.
• Confirm that all work has been completed and spa is functioning correctly.
• Install supplied warning safety sign in a location clearly visible from spa.