Owner`s manual

SPA TROUBLE-SHOOTING GUIDE
40
PROPULSION SYSTEM (CONT.)
Light will not turn on
1. Verify that light switch is on
2. Verify that appropriate voltage is being supplied to light
3. Replace light
NOTE - Max. frequency setting f/wave XP Pro: 68 HZ.
FILTRATION
Filter pump will not turn on
1. Verify that E-stop is not tripped
2. Check voltage to filter pump contactor
3. Verify that contactor coil is getting the appropriate voltage when E-stop is active
My chemicals are balanced (PH, TA, Sanitizer), but my water is cloudy
1. Shut down unit until problem is remedied and water is clear
2. Clean/replace filter
3. Review bather load and consult with pool professional
SERVICEABLE COMPONENTS:
CRITICAL REPLACEMENT COMPONENTS:
WARNING - Items listed below shall only be replaced with identical components unless approved
by Master Spas engineering department.
• Propulsion suction grate assembly: X804490
• Propulsion grate fasteners (4 per grate): X717900
• Propeller f/wave XP Pro: X400820
PROPULSION SUCTION GRATES MISC. SPECIFICATIONS:
Included serviceable components:
• G.F.C.I./Breaker Assembly
• E-stop
• Spring wound timer
• VFD
• Propulsion Motor
• Propulsion transmission system
• Belts
• Pulleys
• Bearing/hub assembly
• Propeller
Optional serviceable
components:
• Electrical control box
• Filter pump
• Jet pump 1
• Jet pump 2
• Light
• Filter
• Chlorinator
Other possible serviceable
components:
• Chemical maintenance
system
• Heater
• Ozone Generator
• UV System
• Other water sanitization
system
• Maximum VFD frequency – 68Hz.
• Wall mount only
• Grate / frame assembly P/N – X804490
• Propulsion grate fastener P/N – X717900
• Propeller P/N –X400820
• Life span 7 years
• Tools required – No. 2 Phillips screwdriver
• Pulley system shall be 1:1 ratio only
NOTE - Fitting and fasteners should be observed for damage or tampering before each use of the spa.