Owner`s manual

America’s Leader In Luxury
MASTER SPAS
45
DOWN EAST (3 -4 PUMP SYSTEMS)
East Hampton SE / Portsmouth SE / Windsor SE / Windsor STS /
Exeter SE / Westbrook SE /Cape Cod SE (4 Pump System)
Initial Start-up
When your spa is first actuated,it will go into Priming mode, indicated by "Pr."
Be sure the pumps and heating system are free of air by cycling the pumps on
and off with the spa-side panel buttons.The spa will not heat during priming
mode,allowing time to verify all air is purged from the heater.The Priming
mode will last for less than 5 minutes (press "Warm" or "Cool" to skip Priming
Mode) and then the spa will begin to heat the spa and maintain the water
temperature in the Standard mode.
Note: Refer to p. 51 for Mystic operations.
Your system has a 24-hour circ pump.The circ pump and the ozone
generator run continuously.
Warm/Cool (80˚F - 104˚F / 26˚C - 40˚C)
The start-up temperature is set at 100F°/37°C.The last measured temperature
is constantly displayed on the LCD.
Note: The last measured spa temperature displayed is current only
when the circ pump has been running for at least 2 minutes.
To display the set temperature,press the "Warm" or "Cool" pad once.
To change the set temperature,press the pad a second time before the LCD stops
flashing. Each press of the "Warm" or "Cool" pad will continue to either raise or
lower the set temperature.After three seconds, the LCD will stop flashing and
display the current spa temperature.
East Hampton 3 / Portsmouth 3 / Windsor 3 / Exeter 3 / Cape Cod 3 /
Westbrook 3 (3 Pump System)
07 Master/DE/Freedom Owners Manual 5/3/07 2:31 PM Page 46