Owner`s manual

____________________________________________________________________________________________
__________________________________________________________________________________________
16
FILTRATION
FILTRATIONFILTRATION
FILTRATION
Your spa will automatically filter itself twice each day. The first filter cycle will begin
one minute after the spa is energized. The second filter cycle will begin twelve hours
after the start of the first filter cycle. The standard setting from the factory is a 2-hour
cycle twice a day totaling 4 hours daily. This setting is able to be changed by your dealer
to a 5-hour cycle twice a day totaling 10 hours daily depending on your individual usage.
During filtration, the ozone generator (if installed) will run.
OZONE
OZONEOZONE
OZONE SYSTEM
SYSTEMSYSTEM
SYSTEM (OPTIONAL)
(OPTIONAL)(OPTIONAL)
(OPTIONAL)
Your ozone system will operate whenever the spa is in its normal filtration cycle.
LED
LEDLED
LED ERROR
ERRORERROR
ERROR INDICATOR
INDICATORINDICATOR
INDICATOR
Your LED will readout the following if any problems are detected:
OH “Overheat Protection” - If your spa should overheat, the display will read
“OH.” In such a condition do not enter the water. Turn off the power and contact
your dealer or service center. To re-set the spa, press any of the control pads.
FL “Flow Switch Detection” - If a pressure switch malfunctions, the display
will read “FL.” This could be caused by a simple flow restriction. Please refer to
the “Trouble Shooting Guide” or contact your service center.
SN “Open Sensor” - If either the high limit or water temperature sensor
malfunctions, the display will read “SN.” Contact your dealer or service center.
WARNING
WARNING WARNING
WARNING -
--
- THERE IS A SHOCK HAZARD AND THERE ARE NO USER SERVICEABLE PARTS.
THERE IS A SHOCK HAZARD AND THERE ARE NO USER SERVICEABLE PARTS.THERE IS A SHOCK HAZARD AND THERE ARE NO USER SERVICEABLE PARTS.
THERE IS A SHOCK HAZARD AND THERE ARE NO USER SERVICEABLE PARTS.
Do not attempt service of this control. Contact your dealer or service organization for assistance.
Follow all owner’s manual power connection instructions. Installation must be performed by a
licensed electrician, and all grounding connections must be properly installed.