Owner`s manual

____________________________________________________________________________________________
__________________________________________________________________________________________
9
• Exposure to sunlight and shading from trees
• Privacy
• Getting to spa from house and return
• Proximity to dressing rooms and bathrooms
• Storage for spa chemicals
• Local building codes ( if applicable)
• Power cable (see electrical requirements)
GENERAL CONSIDERATIONS FOR INDOOR INSTALLATION
GENERAL CONSIDERATIONS FOR INDOOR INSTALLATIONGENERAL CONSIDERATIONS FOR INDOOR INSTALLATION
GENERAL CONSIDERATIONS FOR INDOOR INSTALLATION
Installing your spa indoors creates an entirely different set of considerations. Here again,
with proper planning, no matter what room you spa goes in, it will be your favorite room.
• Work with your Down East Spa dealer and contractor to insure
all local building, electrical and plumbing codes are met
• Plan for a floor drain to drain off excess water or for draining
and cleaning your spa
• A ventilation fan may be necessary due to high humidity
created by your spa
• Finished material in your spa room should also be capable of
withstanding increased humidity
INITIAL
INITIALINITIAL
INITIAL START
STARTSTART
START-
--
-UP
UPUP
UP PROCEDURE
PROCEDUREPROCEDURE
PROCEDURE
Now that all electrical connections to your new Down East Spa are complete, start-up
procedures may begin. This is the fun part!
CAUTION
CAUTION CAUTION
CAUTION -
--
- DO NOT APPLY POWER T
DO NOT APPLY POWER TDO NOT APPLY POWER T
DO NOT APPLY POWER TO OR OPERATE THE SPA
O OR OPERATE THE SPAO OR OPERATE THE SPA
O OR OPERATE THE SPA WHEN TH
WHEN THWHEN TH
WHEN THE
E E
E
SPA IS PARTIALLY FIL
SPA IS PARTIALLY FILSPA IS PARTIALLY FIL
SPA IS PARTIALLY FILLED OR THERE IS NO W
LED OR THERE IS NO WLED OR THERE IS NO W
LED OR THERE IS NO WATER IN THE SPA!
ATER IN THE SPA!ATER IN THE SPA!
ATER IN THE SPA!
1) Be sure that the circuit breaker in you breaker panel is off.
2) Be sure all jets in the spa are fully open by turning the jet face counter-clockwise.
3) LOCATE AND OPEN ALL VALVES. NOTE: There are two valves per pump.
Pump locations vary depending on model of spa.
4) Be sure drain fitting is fully closed.
5) Fill your new Down East Spa with water. Fill to waterline, which is approximately
three inches above bottom of filter/skimmer opening.
6) Bleed air from system by briefly opening the external drain fitting then close.
Turn breaker switches on. You may then press any of the spa function
switches. After power has been applied for one minute your spa will
automatically move into its pre-set filter cycle. (See operation section
for further information.)