Owner`s manual

WATER QUALITY MAINTENANCE SCHEDULE

BEFORE EACH USE - Check spa water with a test strip for proper sanitation

levels and adjust accordingly to the proper levels.

ONCE A WEEK - Add 3 Tablespoons of a non-chlorine shock or

1 teaspoon of Dichlor to spa per 250 gallons.

3 TIMES A WEEK - Test water using chemical test strips. Adjust sanitizer,

pH and Alkalinity accordingly.

ONCE A MONTH* - Soak your filter element overnight in a bucket with

spa Filter Cleaner and then rinse with clean water

before re-inserting.

EVERY 180 DAYS - Drain and refill your spa. Repeat start up procedure.

AFTER EACH USE - Add 1 tablespoon of non-chlorine shock or 1/3

teaspoon of Dichlor to spa per 250 gallons.

AS NEEDED - If water looks hazy, shock treat with 1 teaspoon of

Dichlor per 500 gallons.

* These are general recommendations for water quality maintenance that

may vary by usage and or bather load. Depending on bather load and

frequency of use, drain and refill times may vary as well as the frequency

of cleaning your filters.

* Foam Gone may be used when excessive foaming occurs. Be sure to use

only a drop or two at a time. Over use of Foam Gone will result in cloudy,

milky water.

NOTE:

As an alternative to non chlorine shock, Dichlor may be substituted.

1 tsp. Dichlor = 3 tablespoons of non chlorine shock

USE ONLY SPA CHEMICALS

(some pool chemicals are not suitable for spa use).

* when cleaning filters, be sure to never have the pump(s) running without

the filter in place. Failure to do so may result in debris in the pumps causing

unwarranted damage.