Owner`s manual

TWILIGHT SPA – CONTROLS

TS6.2•TS7.2•TS7.25•TS8.2•TS8.3

INITIAL START-UP

When your spa is first actuated, it will go into Priming mode, indicated by

“

” Be sure the pumps and heating system are free of air by cycling the

pumps on and off with the spa-side panel buttons. The spa will not heat during

priming mode, allowing time to verify all air is purged from the heater. The

Priming mode will last for less than 5 minutes (press “Warm” or “Cool” to skip

Priming Mode) and then the spa will begin to heat and maintain the water

temperature in the Standard mode.

Warm/Cool (80°F - 104°F / 26°C - 40°C)

The start-up temperature is set at 100F°/37°C. The last measured temperature is

constantly displayed on the LCD.

Note that the last measured spa temperature displayed is current only when the

low speed of pump 1 has been running for at least 2 minutes (temperature is

always current on spas equipped with 24 hour circulation pump). To display

the set temperature, press the “Warm” or “Cool” pad once. To change the set

temperature, press the pad a second time before the LCD stops flashing. Each

press of the “Warm” or “Cool” pad will continue to either raise or lower the

set temperature. After three seconds, the LCD will stop flashing and display

the current spa temperature.

Jets 1

Touch the “Jets” button once to turn pump 1 on or off, and to shift between

low and high speeds. If left running, the low speed of the pump will automati-

cally turn off after 4 hours, and the high speed will automatically turn off after

15 minutes.

Jets 2

Touch the second “Jets” button once to turn pump 2 on or off. If left running,

pump 2 will automatically turn off after 15 minutes. This pump has one speed.

Jets 3 (If so equipped)

Touch the second “Jets” button once to turn pump 2 on or off. If left running,

pump 3 will automatically turn off after 15 minutes This pump has one speed.