Owner`s manual

SPA TROUBLE-SHOOTING GUIDE

NOTHING ON THE SPA OPERATES-

1.) Check the control panel display for any messages. If there is a message,

refer to the diagnostic section. There you will find the meaning of the

message and what action is to be taken.

2.)

If there is no message on your control panel, check and reset the GFCI and

house breaker. If the spa does not respond; contact your local service company.

TS 120 only: The GFCI cord should be plugged into a weather proof receptacle close

to the spa, but no closer than 5 ft. to the spa. If the spa does not respond make sure

to check and reset the GFCI breaker attached to the plug end of the cord.

If the spa does not respond, contact your local service company.

PUMP(S) DO NOT OPERATE -

1.) Press the “Jets” button on your control panel.

If you hear the pumps trying to operate:

A. Pump may need to be primed. See page 17.

If you do not hear anything from the pump, contact your local service

company.

POOR JET PERFORMANCE

1.) Make sure pump is operating

2.) Check that the water level is adequate (up to minimum safe water level side)

3.) Make sure the jets are open.

4.) Check for dirty filter. Clean if necessary.

* The GFCI should be located in a weather proof box

close to the spa, but no closer than 5 ft.