User's Manual

ManualsBrandsMasterbuilt Manufacturing ManualsElectronicsRemote controller for 30 inch Electric Smoker and 40 inch Electric Smoker

To replace batteries:

• Slide belt clip to the left to remove.

• Press tab down on battery cover and pull out.

• Install 2 “AAA” Alkaline batteries. Check positive (+) and negative (-) symbols, on the case and bat-

tery, to insure proper installation.

• Replace the battery cover.

• Remove batteries before storing remote control.

To test frequency range:

• Turn unit on.

• Use remote to turn light on and oﬀ as you move away from unit.

• Remote control is out of frequency range when light will no longer turn on and oﬀ .

IMPORTANT

• Do not leave remote control exposed to sunlight for prolonged periods of time.

• Remote control has frequency range of up to 100ft (30m).

• Test frequency range before and during use.

TROUBLESHOOTING

If the remote is not working properly or not interfacing correctly with the controller, it may be due to

weak batteries, batteries being incorrectly installed or the remote is not correctly linked to controller.

Possible solutions

• Replace batteries and install according to image in battery housing.

• Link remote and controller by:

a. Turn Controller & Remote “ON”,

b. Press and HOLD “SET TEMP” on controller for 3 seconds.

c. On the Remote press “MEAT PROBE”, “LIGHT”, “MEAT PROBE”, “LIGHT” (all buttons must be

pressed within 5 seconds of each other). A short beep will occur after each button press.

HOW TO USE CONTROL PANEL & REMOTE CONTROL

CAUTION

• Keep batteries away from small children. If battery is swallowed consult a physician immediately.

•

Be sure to insert batteries correctly. Improper installation may result in leaks and/or possible explosion.

• Do not dispose of batteries in ﬁ re.

• Do not mix old and new batteries.

• Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh,etc) batteries.

*Batteries not

included

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions :

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

FCC Warning

Warning: Changes or modiﬁ cations to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

FCC Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment oﬀ and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit diﬀ erent from that to which the receiver is

connected.

4. Consult the dealer or an experienced radio/TV technician for help.