Installation Guide

ManualsBrandsMasterbuilt ManualsElectric GrillsVeranda Electric Grill in Red

Masterbuilt Manufacturing, Inc

A Georgia Company

1 Masterbuilt Court

Columbus, Georgia 31907

Customer Service 1-800-489-1581

Failure to follow these warnings and instructions properly could result in fire or explosion, which could

cause property damage, personal injury, or death.

ASSEMBLY, CARE & USE MANUAL

WARNING & SAFETY INFORMATION

THIS PRODUCT IS FOR OUTDOOR USE ONLY

This manual contains important information

necessary for the proper and safe use of this unit.

Read and follow all warnings and instructions before using

grill and during use.

Keep this manual for future reference.

Use only outdoors where it is well ventilated.

WARNING

Tools required for assembly: Phillips Head Screwdriver.

Manual Code: 15080020 081120

ELECTRIC VERANDA

MODELS 20150109, 20150209

Approximate assembly time: 20 minutes.

Summary of content (8 pages)

PAGE 1
Masterbuilt Manufacturing, Inc A Georgia Company 1 Masterbuilt Court Columbus, Georgia 31907 Customer Service 1-800-489-1581 ASSEMBLY, CARE & USE MANUAL WARNING & SAFETY INFORMATION THIS PRODUCT IS FOR OUTDOOR USE ONLY Manual Code: 15080020 081120 ELECTRIC VERANDA MODELS 20150109, 20150209 Approximate assembly time: 20 minutes. Tools required for assembly: Phillips Head Screwdriver. WARNING This manual contains important information necessary for the proper and safe use of this unit.
PAGE 2
GENERAL WARNINGS AND SAFETY INFORMATION • Use GFI protected electrical outlet to reduce the risk of electrical shock. • Never burn charcoal or wood in this unit. • Place unit on a level surface to prevent possible tipping. • To avoid injury disconnect electric cord from outlet before cleaning and servicing. • To reduce risk of electric shock, keep extension cord dry and off the ground. • Minimum distance from side and back of appliance to walls or railing is 24 inches.
PAGE 3
APPROXIMATE GRILLING TIMES GENERAL WARNINGS AND SAFETY INFORMATION BEEF Steaks SIZE GRILLING TIME INTERNAL TEMP /4” (2cm) thick 3 to 4 min. /side med rare 145°F (62°C) 4 to 5 min. /side med 160°F (71°C) 3 Kabobs 1” (2.5cm) cubes 3 to 4 min. /side 145°-160°F (62-71°C) Hamburger patties 1 /2” (12mm) thick 3 to 4 min. /side med 160°F (71°C)) 4-6 lbs. (1.8-2.7kg) 18 to 22 min /lb. 145°-160°F (62-71°C) Sirloin tip 3 1/2--4 lbs. (1.5-1.8kg) 20 to 25 min. /lb.
PAGE 4
GENERAL WARNINGS AND SAFETY INFORMATION continued • Never use electric grill as a heater. • Use electric grill only on a level, stable surface to prevent tipping. • Electric grill is HOT while in use and will remain HOT for a period of time afterwards. Use caution. • Do not allow anyone to conduct activities around electric grill during or following its use until the unit has cooled.
PAGE 5
PARTS LIST TROUBLESHOOTING GUIDE 10 SYMPTOM Power light won’t come on. CAUSE POSSIBLE SOLUTION Not plugged into outlet Check outlet connection Control unit cord not plugged into base pan Check unit connection House fuse tripped Make sure other appliances are not operating on the same electrical circuit. Check household fuses Controller malfunctioning Contact Masterbuilt at 1.800.489.
PAGE 6
HARDWARE LIST REPLACEMENT PARTS LIST ITEM NO.
PAGE 7
Before assembly read instructions carefully. STEP 7. Place cooking grate (7) inside grill base (2). Tools needed for assembly: Insert grease cup (6) into back of pedestal top (3). 8 Phillips Head Screwdriver Connect control unit (8) to grill base (2). 4 Assemble unit on a clean, flat surface. 7 E 3 Carefully position grill as shown. 2 STEP 1. Attach pedestal middle (4) to pedestal base (5) using phillips flange screws (E). 5 6 GRILL IS READY FOR USE. STEP 2.
PAGE 8
STEP 5. STEP 3. Attach grill base (2) to assembled pedestal top (3) as shown using phillips flange screws (E). 10 1 Insert temperature gauge (10) into grill lid (1) as shown. Secure using wing nut (B). 2 E F 3 STEP 4. 2 11 D STEP 6. Insert element (11) into grill base (2) as shown. Align holes in element and grill base. Secure using thumb screws (D). Align hinge on grill lid (1) with hinge on grill base (2). Insert hitch pin (A) through aligned holes as shown.